raybet雷竞技官网在线下载_raybet雷竞技竞猜苹果版

One-feed one-pull punch feeder

2020-07-03(1072)Views

In addition to the conventional automatic feeding method of the machine device at the mold inlet and the method of the machine device being forced to pull the material at the die outlet, the long-punch feeder can also install two punch feeders in the Special one-for-one feeding is carried out on the same punching machine.

One-pull and one-feed feeding method: by automatically feeding two punch feeders at the mold inlet, one device is forced to pull at the mold outlet to ensure ultra-thin board data and electronic Industry soft materials feed. The punch feeders used by the one-pull and one-feed device method provided by Jiuji for customers are mainly five types of air feeders, roller feeders, servo feeders, and clip feeders. There are four common methods of deployment:

　　 1. One-for-one type of air feeder. The air feeder is one-for-one-pull type. It is mainly used in traditional punch presses. It is suitable for feeding occasions where accuracy is not high and speed is not fast. The advantage is that the price is economical and affordable. At the same time, the degree of customization is high. E-type feeding solenoid valves can be added according to demand And R-type relaxation solenoid valve, and the powerful air type can be used. The defect is that the precision is not high and needs special protection and maintenance.

　　 2. One-for-one type of roller feeder. The one-for-one type of roller feeder is mainly used in traditional punch presses. This type is special. The two sets will share a set of transmission devices such as eccentric discs, tie rods, and rocker arms. It is suitable for processing occasions with small data widths and within 300 steps. , Commonly used for stamping processing of metal buttons and corns, the defect is that the degree of customization of the machine is not high, and the punch needs to have an output shaft.

　　 3, NC servo feeder one-for-one-pull type. The NC servo feeder is one-for-one-pull type. It is mainly equipped with fine pneumatic punching machines. Two NC feeders and two electric control systems are suitable for fine stamping occasions. The advantages are easy operation, high precision, good stability, and wide application range. The feeding step can reach 0-10m.

　　 4. Clamp feeder with NC servo feeder, one-for-one-pull type. The clip feeder is equipped with NC servo feeder. The one-feed one-pull type is mainly used for high-speed punching. It is usually fed by clip feeder and NC servo feeder. This type is mainly used in the field of high-speed fine stamping in the electronics industry. The feeding speed is fast, the precision is high and stable.

<No Large deflection material rack with deflection NC servo feeder> Backtrack